Hi Guys,
I have a Mossberg 500 shotgun with 3 barrels, one of them being a rifled cantilever barrel with a weaver mount.
The problem is that if I mount a red-dot sight on it (the one I have laying around) the sight line becomes too high and I don't get any cheek weld. I don't need a scope anyway as I'm not gonna shoot anything beyond 50 yards.
So far I found only one set of sights made by LPA https://www.lpasights.com/en/products/sht04w/. However, apart from being outrageously expensive, the front sight is too small to fit on my barrel, which is 0.95" in diameter.
Perhaps I don't need a rear sight at all? Perhaps I could use the channel of the Weaver rail itself as a rear sight, and only install a lower sitting front sight like this one https://www.mcssl.com/content/assets/44/448986/WEBSITE_OPS12P_MOOBS.png (provided it could fit).
Any thoughts / ideas?
Cheers,
Jaroslav
I have a Mossberg 500 shotgun with 3 barrels, one of them being a rifled cantilever barrel with a weaver mount.
The problem is that if I mount a red-dot sight on it (the one I have laying around) the sight line becomes too high and I don't get any cheek weld. I don't need a scope anyway as I'm not gonna shoot anything beyond 50 yards.
So far I found only one set of sights made by LPA https://www.lpasights.com/en/products/sht04w/. However, apart from being outrageously expensive, the front sight is too small to fit on my barrel, which is 0.95" in diameter.
Perhaps I don't need a rear sight at all? Perhaps I could use the channel of the Weaver rail itself as a rear sight, and only install a lower sitting front sight like this one https://www.mcssl.com/content/assets/44/448986/WEBSITE_OPS12P_MOOBS.png (provided it could fit).
Any thoughts / ideas?
Cheers,
Jaroslav