Is There A Cure? Powder Clings To Plastic Feeder

[avsecb2]

I noticed that powder clings (I guess from static) to my Lee powder feeder when I empty it to change powders. Maybe it clings and affects my loads too. Anyone know of a cure?
Clings to my funnel too.

 

[thunderflash]

Try wiping the inside of the powder funnel , or the inside of the powder measure with a sheet of "Bounce" the ones you usually throw in your laundry dryer to eliminate static "Cling".

 

[avsecb2]

Try wiping the inside of the powder funnel , or the inside of the powder measure with a sheet of "Bounce" the ones you usually throw in your laundry dryer to eliminate static "Cling".

BRILLIANT!! Glad I can use your brains on this site. Saves wear and tear on mine. THANKS!!!

 

[willwagspal]

static cling

Try wiping the inside of the powder funnel , or the inside of the powder measure with a sheet of "Bounce" the ones you usually throw in your laundry dryer to eliminate static "Cling".

I cut a couple of 1" strips of "Bounce", taped them to the outside of the powder measure and flipped them over so they hang inside the measure about 1/2 to 2/3 of the way down. Eliminated the cling problem and easy to replace when you need fresh strips.

 

[doc25]

I heard about putting the measure in dish washing detergent and water then allowing it to dry without rinsing it.

 

[tgt40]

Usually all you need to do is to run a couple of pounds of powder through the measure. The problem then just goes away.

 

[John Y Cannuck]

The 'Bounce' idea really works.