JR Carbines - Curious

[slowpoke55]

how much for the shroud

I am pretty sure it is sold already , for 50$

 

[stevey3737]

Here is mine in 9mm flavour, bought it used, added a few bits and I love it and its fairly accurate as well, absolutely amazing that this is 10 shots and completely non restricted but my m4 which to the layman looked pretty frickin similar is restricted, what a crazy place we call home, but as far as the JR goes I am not complaining, had a bit of trouble when I first received it with a screwy trigger group but it is sorted out now and runs very well i would recomend it to everyone just my two cents

 

[Can-down]

Wasn't that hard . Barrel is .75" same as AR
Didn't use the AR cross pins as the 40 cal bore is a lot larger than 223 & the cross cuts in the barrel for the taper pins would have in my opinion been to close to the bore . I drilled & tapped the bottom of the site base & used a set screw that locates in a small indent put on the bottom side of the barrel.
You need to make sure you have it indexed correctly or the site will be off center .
But if you know what you are doing it's not that hard

Nice, Looks great!