Just finished my new upper. Picture heavyish.

[kennyclone]

Big thanks to Tier One Armoury in Edmonton for helping me out getting the parts and installing everything for me at reasonable prices and doing a great job while they're at it.

Parts list was
-BCM KMR 13"
-Lantac Dragon 5.56
-ALG SPB
-Noveske Rail panel kits
-Seekins Precision Adjustable Gas Block
-Daniel Defense 18" barrel with midlength gas block. and the gas tube to go with it.
-Geissele SD-E

I highly recommend this store, great people to chat with, very helpful and upfront and even had a URX tool to uninstall/install my rail. They even have black hills ammo! hello mk262.

they took the old URX 3.1 off the 14.5 and installed the KMR onto it.

the break is so sweet, even compared to my KAC two stage before it.

Great lineup on the VLTOR upper with the URX.

KMR is great and lightweight

Needs a new paintjob, and a new ADM mount which they will be ordering.

 

[mikethebike]

almost a mk12 if only you had gone with a douglas or noveske

 

[kennyclone]

almost a mk12 if only you had gone with a douglas or noveske

I'll see how she shoots tomorrow with the Black hills 77 Gr ammo.
might upgrade to a Noveske barrel down the line but its not on my list for now.

 

[Lszwajda]

Very nice setup

 

[driller212]

Very nice! May I ask how you did that camo job? I like it a lot! I have yet to visit Tier One, but it is on my list.

 

[kennyclone]

Very nice! May I ask how you did that camo job? I like it a lot! I have yet to visit Tier One, but it is on my list.

pretty simple actually,
Degrease your rifle before hand with mineral spirits or alcohol
Spray base coat I did green
Spray next colours you choose in Large S pattern or at a Angle
Repeat until desired pattern is achieved.
to dull it all I lightly spray brown all over it.

 

[JC24237]

These are two great looking ARs. As for your comment "Needs a new paintjob", I think the paintjob is on point!

 

[Trinimon]

Looks great!

 

[cr5]

Looks good. What BCG did you go with?

I was tempted by a few new parts the day I saw you there grabbing the last of your parts but I showed great restraint and walked out empty handed. I guess that depends how you look at it though, I had Dale order me the MDT skeleton stock for my TAC-21 chassis
Next time I'm in there I think I'll grab one of those Noveske uppers they have and swap over my parts from my 16 inch build that I used an NEA upper for.

We should try to line up a day when a group of us can meet there to BS and clean out some of their stock
Tier One is by far my favorite shop to visit for good conversation and great parts for my builds.