know anyone with thin wall choke tooling ?

[roccoskeet]

Good evening all :

I'm looking for a gunsmith or competent person with choke tooling.

I have a O/U that a previous owner had screw in chokes put in top barrel only.
It is True choke thin wall
"0.775 x 44 tpi

I have true choke tooling in "0.795 x 44 tpi
but the barrel O/D diameter is not large enough for me to do the work with what I have.
If anyone knows of a gunsmith or competent person that might have Think wall tooling I would greatly appreciate contact information.

Thanks for your looking and your time.

Cheers
RE

 

[bert pietrangelo]

Good evening all :

I'm looking for a gunsmith or competent person with choke tooling.

I have a O/U that a previous owner had screw in chokes put in top barrel only.
It is True choke thin wall
"0.775 x 44 tpi

I have true choke tooling in "0.795 x 44 tpi
but the barrel O/D diameter is not large enough for me to do the work with what I have.
If anyone knows of a gunsmith or competent person that might have Think wall tooling I would greatly appreciate contact information.

Thanks for your looking and your time.

Cheers
RE

Rocco what you are looking for is a .775 X 44 thin wall colonial tool choke reamer and tap. I think I can help you. But first make sure the barrel O.D is larger than .810. I know the colonial tool manual says .805 O.D in minimal size, but after 30 yrs and hundreds of barrel installs you might be cutting it to close with the .805O.D.