Does anyone else have any problems with powder spilling from the measure between the disk and the frame that it is screwed onto? As the powder disk is moving forward sometimes the powder will come out the front and fall down into the shell plate and primer area and then all hell breaks loose. I have taped some duct tape onto the front of the powder measure to try and stop this problem but eventually it jams. Any idea's?
Lee 1000 problems
- Thread starter hunter64
- Start date
Do you have thePro Auto-Disk Powder Measure on your 1000? If so, it sounds like the rubber "gasket" between the hopper body and the powder disk is worn out. Try removing it and flipping it over as a short-term fix, and order a couple of new ones. I replace mine often. :wink:
