Lee custom case length gauge
- Thread starter 4fifty8
- Start date
- Location
- Kitscoty Alberta
I have these for just about every caliber I load for
They work great for me
They work great for me
Bubba Yugga
CGN frequent flyer
- Location
- Midwestern Ontario
I REALLY don't know why I bought the one in 9mm Luger.
Maybe one of those "while I'm at it" moments...
Where do you order these? I was looking for some at my LGS, but no go.
- these work pretty good for me for case trimming
- .416 Wby not listed so did custom order
- 2.903" trim-to-length, 0.416" bullet dia. & shell holder #8 specified
- placed order 3 week turnaround Lee done good
Higginson Powders sells Lee stuff at good prices and has a pretty large amount of stock. Assuming you want standard ones and not the custom order in OP...
Mark
- Location
- Blaster land, Okanagan BC
Glad I’m not the only one haha.
saskgunowner101
CGN Ultra frequent flyer
- Location
- near Prince Albert
Wait...you mean to tell me that you guys don't use a file and eyes an eagle would be jealous of to trim brass? I really got to get my act together...
I'm only half kidding lol
I'm only half kidding lol
BlackPowderBurner
CGN frequent flyer
- Location
- the chesterfield
I rub mine case mouth down on dry sandpaper while listening to radio static.Wait...you mean to tell me that you guys don't use a file and eyes an eagle would be jealous of to trim brass? I really got to get my act together...
I'm only half kidding lol
saskgunowner101
CGN Ultra frequent flyer
- Location
- near Prince Albert
Maybe someday when I sell all the #19 shellholders I seem to have amassed, I too will be a baller such as yourself.
- Location
- Western Manitoba
I would get one for .416 Rem Mag, but I still have many new cases to fire first - I am presuming that brass case makers know what the length should be, so I have never measured new cases, but the case goes through the length trim and chamfer, and de-greasing, as part of my re-sizing process.
- Location
- Western Manitoba
I believe when I inquired at Rusty Wood some months ago, that I was told that Lee does not make any .416 case length trimmers that could be turned on my lathe to use in .416 Rem Mag - they do not regularly stock for 416 Taylor, 416 Rigby or 416 Weatherby. I have made a 9.3x57 trimmer by shortening a 9.3x62 to length - it is my intent to create a 9.3x57 FCD from one for 9.3x62, but I have not done that yet.
- US$20.00 for custom case length gauge see listed exclusions https://leeprecision.com/Custom-CLG
- did .416 RM custom case length gauge order years ago looks like it's still custom order
- .416 Rigby case length gauge listed in stock got 1 while back https://leeprecision.com/gage-holder-416-rig
