lend/rent 45 cal reamer

blindside

blindside

BANNED
BANNED
BANNED
EE Expired
Rating - 100%
20   0   0
Location
The hills of the Frew
If anyone has a a straight 45 cal reamer that is either for rimmed chambers 2.4" + or rimless they would lend/rent. As long as it has an end dia of .482 or bigger. I need it to extend the neck of a 450 alaskan chamber just a few thou on a ruger #1. It will be in the hands of a retired tool maker. If its returned to you not suiting your liking it will be replaced....Some that come to mind. 45/90/100/110,etc,etc in rimmed....Any belted ie 458 lott. not 458 wm. free bore to big..In the rimmed the win/wcf ones typically come closer to the .482 dia. the sharps tend to be small.
Thankyou anyone kuduboy@sympatico.ca
 
Last edited:
"...450 alaskan..." That's the reamer you'd need. Not just a .45 cal reamer. Chamber reamers are specific to the cartridge.
There are some reamer rental places Stateside, but I don't know if they'll send one out of their country. Do a net search for it.
 
sunray said:
"...450 alaskan..." That's the reamer you'd need. Not just a .45 cal reamer. Chamber reamers are specific to the cartridge.
There are some reamer rental places Stateside, but I don't know if they'll send one out of their country. Do a net search for it.
Click to expand...

Once you've done the chamber in 450 AK if the neck length is to short, then you need something that will just chase the neck....Which to go back to where I was before confusion set in was a straight 45 cal reamer with .482"+ at the end. Once again thankyou to anyone with useful input
 
You must log in or register to reply here.
Back
Top Bottom