Leupold rings question

[72mustang]

I have a marred up screw for a Leupold regular ring mount. Question...

- are all the screws the same size ? ( the 2 screws that hold the rear ring on the base ) for each calibre/model ?

- can you purchase just the screw seperatly ? If so... where ?

 

[bearkilr]

Diameter can vary, though most rifles have the smaller 6x48 screws. Length varies depending on make of rifle otherwise the screw can protrude into the action binding the bolt. What kind of rifle?

Your best bet is to go see a gunsmith, they have tons of little screws. Bring the original along. Another option is to buy new bases with screws, they're about $30 for most makes.

 

[72mustang]

Diameter can vary, though most rifles have the smaller 6x48 screws. Length varies depending on make of rifle otherwise the screw can protrude into the action binding the bolt. What kind of rifle?

Your best bet is to go see a gunsmith, they have tons of little screws. Bring the original along. Another option is to buy new bases with screws, they're about $30 for most makes.

No. Your talking about the screws that hold the base to the top of receiver. Im talking about the screws (bolts ) that hold/secure the bottom part of the ring onto the base to lock it in. Flathead screwdriver to tighten. Are all these the same size since its ony a 1in ring ?

 

[bearkilr]

Windage screws on rear base. Should all be the same, though I don't know if they're sold separately. Again, your best bet may be to buy new bases if they're that bad, or try the biggest screwdriver you can find and use blue loctite on threads.