Limbsaver size for Hogue stock?

[Jim Rock]

Anyone know which number limb saver fits on a Hogue 870 over mould stock? They only list firearms manufacturers on their site. I am hoping at least 1 will be the same profile, hopefully someone out there has had some luck...

 

[SwifTst]

I went through this a few months ago in Canadian Tire. I didn't have time to do any research, but I did have my hogue stock with me (short). Couldn't find one that fit perfectly, so I went with the smallest one. Top screw lines up, but iI had to glue a small block of wood iinside the stock for the second lower screw. The maxi pads iis still a but big for the stock, but I just used electrical tape and it looks and functions fine. I usually wrap electrical tape on all my recoil pads to stop them from grilling my clothing as iI shoulder the gun.

Not exactly the info you're looking for, but hope it helps

 

[K-C]

There is a pdf download on the LimbSaver site. It is a multi-page document that you print "full-size" as it has templates for all their recoil pads. Just place the butt of your stock onto each template to find the right one.

This link will give you a direct pdf download: http://limbsaver.wpengine.netdna-cdn.com/RecoilPadTemplateGuide.pdf

 

[Silverback]

Send Limbsaver an e-mail and ask them, I did it this week for a rifle stock I have and they got back to me the next day.

 

[Jim Rock]

Thanks guys!