Little Problem with Sights.

[RDevigne]

It appears the rear sights on my Kimber .22 Conversion is a little loose. It can travel side to side i would say approx 1mm. My first thought was to crazy glue it however comon sence told me to post first. I'm assuming that a small amount of glue is applied at the factory to keep keep the sights in place but im not sure. Is there a specific product i should be using ?

 

[RDevigne]

Dam..

 

[redleg]

There should be a set screw onder the sight. Crank it down. If you want to use locktite, most manufacturers recommend red on sights.

 

[RDevigne]

After taking apart the Windage assembly I noticed a hex style screw that loosens and tightens the Rear right on the slide. No Crazy Glue neded here Baby .

I think it got loose because the rear sight was set so low that the hammer was actualy coming in contact with it during fire. After some shots I guess the hammer knocked her loose. Now i make sure that there is proper clearance

Thanks

Cheerz,
Rob