I have just bought used a couple of Lee molds, 130 gr single cav and 135 gr double cavity. Bullets will be sized .278 . They will be plenty hard, using linotype Pb and powder coating and adding gas check.
Not finding a lot of load data, for these bullets
Would like to use powders I have, such as IMR 4895, Varget,
Lyman cast manual only lists 2 loads, both Lyman molds, 140 and 150 gr
any help much appreciated.
and with all due respect, no comments please on why I am doing this, it is my hobby, have been successful making great rounds for other calibers, just need a starting point , without reinventing the wheel.
Not finding a lot of load data, for these bullets
Would like to use powders I have, such as IMR 4895, Varget,
Lyman cast manual only lists 2 loads, both Lyman molds, 140 and 150 gr
any help much appreciated.
and with all due respect, no comments please on why I am doing this, it is my hobby, have been successful making great rounds for other calibers, just need a starting point , without reinventing the wheel.
