Looking for 7MM Rem mag mouse fart loads

juliansk

Member
Rating - 100%
13   0   0
After reading the threads on these, I'm really interested in trying this out.
Anyone have a load they have done for 7RM 24" 1:9 twist with titegroup? I have a can of it, and lots of 139gr Interlocks so won't have to go component shopping.
Thanks!
If nobody has tried a load I'll start at 10gr and work down in 0.2 increments. Just nice to have a starting point.
 
I am interested to hear of any recipes. I have loaded the 139s with some 4064 and it was soft shooting compared to the full power loads. Still not as soft as some trailboss loads in the 308, so hopefully someone chimes in
 
IMR TRAIL BOSS REDUCED LOADS FOR RIFLE AND PISTOL (has one load for 7mm Mag)

https://www.google.com/url?sa=t&rct...oads-r_p.pdf&usg=AOvVaw36_OGGZV785lkqWrnoGv37

1. Find where the base of the bullet to be loaded is located in the case and make a mark on the outside of the case at
this location. Then fill the case to that mark with Trail Boss, pour into the scale pan and weigh. This is your
maximum load. Pressures will be below the maximum allowed for this cartridge and perfectly safe to use!

2. Take 70% of this powder charge weight (multiply the maximum load from step 1 by .7), and that is your starting
load.

3. Start with this beginning load and work up to your maximum charge, all the while searching for the most accurate
reduced load. Once found, the fun begins!
 
Hodgon data says min 17.2 grs. 1405 fps,21,400 psi-max 24.5 grs,1724 fps,31,000 psi for trail boss and 140 gr nosler partition
 
Back
Top Bottom