Looking for a Mauser gunsmith

E

EGT

New member
Rating - 0%
0   0   0
Hey folks, newbie here. Did some searching but couldn't come up with much. Im looking at buying a barreled fn98 Mauser action in 3006 and would like to put it in a bell and Carson tactical medallist, as well as have the action full length bedded. I know it has a bedding block but I would like it to be bedded against that as well. I also know the magazine is longer than a standard m98 magazine ( because it was made stock at the factory for 3006 rather than being a conversion ) and the aluminum block will have to be relieved slightly to fit properly. Do you guys have any gunsmith suggestions? PM's welcome as well.
 
Where are you located? You will most likely have to mail the components to the person doing the work. B&C stocks had a huge cavity in the forestock that needs to be properly filled before a full length bedding job. Do you have the stock? Ron
 
In Kamloops. No I do not have the stock yet. Also mailing isn't really an issue. That's something I can do.
 
You must log in or register to reply here.
Back
Top Bottom