Looking for AICS mag dimensions

[CanuckR]

I am hoping someone can get me the outside dimensions of an AICS long action magazine. Hoping for better than tape measure dimensions. (calipers please)
Mostly concerned with outside dimensions; width and length but wouldn't mind height as well.

Thanks

 

[Daver_II]

Well, they are tapered.

I am in Ottawa if you want to test one.

I also have callipers, but unless you can specifically tell me where you need measured, it would be useless to just measure wherever.


Correction... mine are short action.

 

[CanuckR]

Well, they are tapered.

I am in Ottawa if you want to test one.

I also have callipers, but unless you can specifically tell me where you need measured, it would be useless to just measure wherever.


Correction... mine are short action.

Thanks for the offer. I am playing with 3D printing a bottom metal, and perhaps a magazine or 2 if it works out. Edited post to specify outside dimensions.

 

[CanuckR]

Anybody out there with a magazine and some calipers have 5 spare minutes?

 

[ViktorF]

I think the MDT ones are fairly cheap. The first patch had some fitting issues from what I understand...but they were easily fixed with sand paper.

 

[photog_shooter]

Mine (300 win mag) shows length of 3.683", width of 0.720" and height of 3.352" front and 3.636" rear (not including feed lips).

 

[Daver_II]

Thanks for the offer. I am playing with 3D printing a bottom metal, and perhaps a magazine or 2 if it works out. Edited post to specify outside dimensions.

Interesting. Let me know how it works out.