Looking for info on FAL stocks

[suprathepeg]

Could someone get the specs on a fal stock? I'm looking for the length, width, height and dimensions of where the stock attaches to the rifle.

 

[Curtton]

Could someone get the specs on a fal stock? I'm looking for the length, width, height and dimensions of where the stock attaches to the rifle.

not FN C1A1? which by the way comes in 4 sizes.

 

[Corpus]

(Length [centerline] X Height [butt-plate] X Width [receiver to butt-plate] in inches.) 10" x 5" x 1"- 1.5" roughly; Measurements taken from my DSA X-Series Butt-stock (which is about as close as you can get for a new production "Humback" FAL butt-stock). That's ballpark; make-up the rest.


X-Series Butt-stock

 

[suprathepeg]

Thanks Corpus. Can you meansure the width and height where it attaches to the lower?

 

[sunray]

"...comes in 4 sizes..." Four lengths. The part suprathepeg is asking about is the same.

 

[suprathepeg]

Anyone?

 

[sunray]

"...Anyone?..." The butt stock and you're looking for the dimensions of where the stock fits onto the receiver, right? You have a rifle? Which one you have matters a bit, but measure the rifle side.

 

[suprathepeg]

If I had one I wouldn't be asking, lol. I'm looking for general info.