M-305 Stripper Clip Guide Block Removal

chad_chewy

chad_chewy

Regular
Rating - 100%
114   0   0
Before I start guessing how to get the pressure pin out of the Norinco stripper clip guide block so I can get a proper scope mount assembly on, can someone tell me the proper procedure how to remove the guide block? As in does that pin have to be drilled out, or can the block be just tapped out?
 
just use a drift pin, or small nail.....file off the end so it's nice and flat.

Take rifle out of stock, with bolt on closed position.....tap out pin.

Then take rubber mallet and convince the clip guide out.....usually they only go one side or another. I'm having a brain fart right now......so I'm going to say it goes to the op-rod side....but it could go the other way.

GG&FB

I'm a slow typer.....someone was faster than I
 
girlsgunsandfastbikes said:
.....usually they only go one side or another. I'm having a brain fart right now......so I'm going to say it goes to the op-rod side....but it could go the other way.
Click to expand...


Yeah, it's been a while for me. I can't remember which way they come off either...if it doesn't come off one way just flip it over and try the other way, lol.
 
The stripper clip block pin is tapped out from the bolt raceway side out through the top of the stripper clip block.and the mammarys are real nice too!!!!
 
You must log in or register to reply here.
Back
Top Bottom