Mag came loose frequently after shots?

T

TTTimothy

Member
Rating - 100%
18   0   0
Location
Edmonton AB
Hi Folks,

I'm shooting a Tikka CTR on a KRG Bravo Chassis (CTR MAG version). I noticed that my magazine frequently became loose after shots which causing feed failure, and I have to press it to snap back in place.
This is quite bothering, and I'm sure that those action screws on the chassis were torqued properly (65in-lb for both)

Anyone have an idea of why it is happening?

Thanks
 
I used a KRG Bravo Chassis for my Bergara B-14 build in December.
I ended up solving the exact same problem (permanently) by putting one piece (in the video at end of post below I was using 2 pieces) of electrical tape in the front of the mag.
Surprisingly, the same piece of tape has worked absolutely flawlessly since.

Not at all familiar with Tikka CTR, but maybe this hack will work....(post #15 in the link)

https://www.canadiangunnutz.com/forum/showthread.php/2223157-Bergara-B-14-in-22lr-and-KRG-chassis/page2
 
Munkey1973 said:
I used a KRG Bravo Chassis for my Bergara B-14 build in December.
I ended up solving the exact same problem (permanently) by putting one piece (in the video at end of post below I was using 2 pieces) of electrical tape in the front of the mag.
Surprisingly, the same piece of tape has worked absolutely flawlessly since.

Not at all familiar with Tikka CTR, but maybe this hack will work....(post #15 in the link)

https://www.canadiangunnutz.com/forum/showthread.php/2223157-Bergara-B-14-in-22lr-and-KRG-chassis/page2
Click to expand...

Wow thanks! I thought it's only me that having this trouble! Yes I'm shooting against a sand bag and I noticed the mag usually bump to the bag when it's loose. And no trouble against the bipod.

Thank you again bud
 
You must log in or register to reply here.
Back
Top Bottom