mec 600 jr

S

sp-10

CGN Regular
Rating - 100%
11   0   0
I've got a mec 600 jr in 12 gauge. I'm having a problem with the resizing and primer remover assembly. The steel rod that attaches it to the rest of the loader is bent. What are my options besides spending $60 on another 12 gauge kit. Where can i got another one?
 
I have a similiar model. Versa Mec. You could order a new rod from MEC. I on occation find the it hangs there as well. It seems to just not line up with the hole that the primer presses through. Try wiggling the hull as you pull down the arm, just to help center it.
 
Why not try an email to MEC. If you explain the problem I am sure that they can supply the required replacement parts for a lot less than $60.00.
--------------------------------------------------------------------------

Contact Information

Hours
Monday-Friday 8:00 AM - 4:00 PM (CST)

For Technical Support call: (800) 797-4632 or e-mail Technical Support.

For Sales call: (800) 797-4632 or e-mail Sales.

Web page problems e-mail webmaster.

Copyright © 2009 Mayville Engineering Company. All rights reserved.
800 Horicon Street Suite 1
Mayville, Wisconsin 53050
(920) 387-4500
FAX (920) 387-5802
 
I just got the same press from my father in law and it had the same problem but it was the bolt that was bent, a standard 1/4" x 3 1/2" or so machine bolt, got one at the local hardware and alls good.
I would check it before ordering parts.
 
You must log in or register to reply here.
Back
Top Bottom