Mesa Tactical shellholder and Surefire forend

geologist

geologist

CGN Ultra frequent flyer
Rating - 100%
61   0   0
Location
Lower Mainland, BC
I used the search function and could not find a thread on this.

I have an HP9-1 with a Spec-ops stock and a Surefire forend. I would like to mount a Mesa Tactical shellholder on the left side of the receiver.

Can I fit a 6 shell holder or do I have to go for the 4 shell holder?

Am I better off going with a Knoxx PowerPak once someone gets them in stock?

Finally is there a Canadian Mesa dealer who accepts credit cards?

Thanks for the help and once again my apologies if this has been covered in umpteen previous posts.
 
What is the length of the Surefire forend? The factory forend on a Rem 870 is too long for the 6 shell holder so I went with a Hogue forend.
Its a good 2" shorter then the original.
 
geologist said:
I used the search function and could not find a thread on this.

I have an HP9-1 with a Spec-ops stock and a Surefire forend. I would like to mount a Mesa Tactical shellholder on the left side of the receiver.

Can I fit a 6 shell holder or do I have to go for the 4 shell holder?

Am I better off going with a Knoxx PowerPak once someone gets them in stock?

Finally is there a Canadian Mesa dealer who accepts credit cards?

Thanks for the help and once again my apologies if this has been covered in umpteen previous posts.
Click to expand...

the 6 fit on my 870 ok. just pop out the pins
 
Geologist,

I just did some surfing and it looks like its short enough to use the 6 shell saddle.

thehighroad.org/archive/index.php/t-84832.html
 
You must log in or register to reply here.
Back
Top Bottom