Mid lenght gas system AR15 bbl whos intrested

badboybeeson

badboybeeson

CGN Ultra frequent flyer
Business Member
Rating - 97%
612   19   5
Location
East ontario
we are going to run a bunch of mid lenght has system barrels
just want to know who would be intrested.
This may be a 1 off run so somthing to think about
These will be the specs
16.5 " Goverment profile
4350 steel
1/9 twist
.556 nato chambered
.750 at the gas port
parkerised finish
M4 feed ramps
Troy Ind low profile gas block.
Brownells Mid gas tube and roll pin

Price would be $269.99

If we do this it will be by pre order only with delivery by the end of jan 2011
bbb
 
I was just thinking of building a 16 inch midlength upper and looking around for parts or an entire upper. Under consideration.

On a related note, do you build uppers with your barrel if a customer sends in a receiver?
 
we are not set up to install site towers but can do just about eveything else
send me a pm with what you have for parts or what you have in mind for a build and i can get you a quote, i have a gunsmith on staff with over 20yrs working on ar15s.
bbb
 
You must log in or register to reply here.
Back
Top Bottom