Mosin stripper clips????????

I find it impossible to push them all down at once, so I grab the first round and push down. I'm sure there is a video out there on it lol

But then my magazine will pop open :( you can't win LOL.
 
If you bought the hungarian & chinese stripper clips, they are the worst of the lot for feeding, especially in tighter receivers. They may work in more worn Finnish mosins. Try to find some russian clips.
 
I normally can't push them all down into the magazine at once. It generally ends up being one or two rounds at a time. I have an original one and have used a friend's reproduction ones without problems.

Also, something that I found out first hand that made using the stripper clip difficult on my Mosins. Make sure the rims of the cartridges are not overlapping and are sitting evenly beside each other.
 
I had a lot of trouble with those &^&%$# things, but then my best buddy gave me a copy of the TEXT BOOK OF SMALL ARMS - 1909 and there it was: nice picture of exactly how to do it properly.

When the charger is loaded, the rounds make a PYRAMID. Outside rounds contact the charger, inner rounds ride on the rims of the outside rounds, middle round rides on the rims of the inner rounds. Do it like this and they actually strip out pretty darned good. _-^-_

And you even have the Tsar's permission to do it this way!

Hope this helps.
 
I do it this way:

Position the clip to feed into the receiver. With your index finger on your right hand, lift the tip of the top round, so it is pointing away from the other rounds (which are pointing straight or down slightly).

While doing this, take your thumb and push the base of the round straight down into the receiver. Maintain the position that the top round is in while pushing hard with your thumb and all your rounds should feed.
 
Well, if you know more about these things than the RUSSIAN ARMY, I guess we'll have to it 'your way'.

I'm just using the RUSSIAN ARMY's way.

Figured that maybe they knew something about it.
 
smellie said:
When the charger is loaded, the rounds make a PYRAMID. Outside rounds contact the charger, inner rounds ride on the rims of the outside rounds, middle round rides on the rims of the inner rounds. Do it like this and they actually strip out pretty darned good. _-^-_

And you even have the Tsar's permission to do it this way!

Hope this helps.
Click to expand...

BINGO! Just like you load a enfield stripper one rim over top of the first.:) Tried every way I could think of then tried loading like a enfield stripper and they stripped into the mag easily.
 
You must log in or register to reply here.
Back
Top Bottom