mossy 590a1 accessory help

Cerendrad

Cerendrad

Regular
Rating - 100%
6   0   0
After a very long wait I finally got my 590A1 special purpose. Mine is like this one but without the rails on the hand guard.
53693.jpg


I just need 3 things to make it complete.

A stock mounted ammo carrier like this one (or maybe holding 1 or 2 more if possible)....
17616.gif


A decent flash light holder maybe like this one but I'm open
zero7one_Elzetta_ZSM_Shotgun_Mount_013.JPG


And on my AR I have a sling adapter like this (below) that I'd like to put on the shotgun . I asume it would fit the same as on an AR.
PGRSABLKTROY.jpg


Does anyone know of one place to get all three? Dealers are welcome to PM me. Thanks for the help.

I'd also like to see pics of yours all done up!!:shotgun:
 
I think that the ammo carrier located on the butt would prove to be uncomfortable with anything like a proper cheek weld, and that position would definitely prohibit shooting from the weak side. I'd opt for a Sidesaddle attached to the receiver, which has the additional advantage of replacing the trigger pin with a screw.
 
Greenhorse six said:
And a Meprolite front night sight for Mossberg shotguns equiped with factory ghost rings.
Click to expand...

where can you get these? i have been looking hi and low for one.

as for the OP, i think a receiver sidesaddle would be a better choice than a stock mounted one IMHO.

Or if i had the gun that you have, i would get both. I opted for a Speedfeed on my gun.

As for the flashlight, Mesa makes a picatinny rail that is very good. i personally opted for the surefire flashlight forgrip. i prefer dedicated flashlights on my guns.
 
You must log in or register to reply here.
Back
Top Bottom