Mould Question

[cooterdog]

Not easy to do but I did it..... I lost my screws to my Lyman 2 cavity .490 round ball mould. The ones lost are the ones that goes through the block holding the handle. Does anybody know how long and what size they are so I can get a couple in town? I know there are replacement kits just I need to make some balls b4 I can get them.
THANKS

 

[ben hunchak]

Should be 10/32, you can also use 10/32 set screw and pin arrangement similar to RCBS setup, I switch over to pin and set screw setup if the std. screws back out during use(caused by heat/banging) when casting.