my Dillon RL 550 DIY case feeder

[WWW226]

dear fellows CGN,

very happy and just wanted to share my DIY case feeder with you.
it was a lot of fun designing and lot of prototyping....which equal to many many long nights...

Now I can pay more attention to my powder charges..

https://youtu.be/3lzRaDq7s4Y

cheers!

 

[Steve O]

Looks great now are you going to be marketing these ? Steve O

 

[Beater]

ill take one..... for 223

 

[bertn]

Very nice!
Where did you source the clear tubing?

 

[WWW226]

Thanks Steve.
I don’t think I could market this device due to the fact it is not
an original design, rather a copy from Dillon and other’s company.

My goal was that it is possible to do it and from not knowing how to use a 2d modeling SW to this, everyone could do it!!

Cheers

 

[WWW226]

Bertn
Clear tubing are from Lee bullet/Case Feeder Parts.
You can order them from Amazon or from Western Metal.
I ordered from Western Metal and locally picked up. No shipping fees.

 

[WWW226]

Beater
I think it is doable, but how some reason, Dillon seems not have the 223’s adapter for it.

For the moment, I use only 9mm.
Will do 223, once I get my hand on an AR.

Cheers

 

[Trinimon]

 

[WWW226]

Thanks Trinimon!
I Didn’t know how to post video in here!!!
Cheers!

 

[WWW226]

ill take one..... for 223

I don’t have any AR@ 223s, but have some brasses.
Out of couriosity, I just went to my press and man, the 223 runs with my 9mm setting !!!!
So, My design could run 9mm and 223 without changing the main setups, except for the loading tubes that needs to be higher and to set two or three 233 cases to be dropped in standby. ( if more, the weigh of the cases would make the pushed out case to be tilt over)

I’m now even more excited!!!
One stone two bird!!
Cheers