NANO Linear comps 223/5.56 1/2x 20 thread

badboybeeson

CGN Ultra frequent flyer
Business Member
Rating - 97%
612   19   5
Location
East ontario
Last edited:
Hey, picked a couple of these up for my eurotrash Rimfires, they look nice, and just heavy enough to also work as a barrel weight.
If you do another run, can you do them without the wrench flats, just keep them round full length, like radial brakes (Tandem cross/VQ).
On rimfires, I don't use crush washers, just a bit of blue locktite and hand tighten 2 grunts lol.
Would make production quicker and easier, and my OCD would be grateful, I wouldn't have to shim to get the flats vertical if they were completely round lol.
 
On rimfires, I don't use crush washers, just a bit of blue locktite and hand tighten 2 grunts
uhhhh .... if you want to retain any semblance of accuracy, hand tight is nowhere near tight enough because barrels vibrate with each shot and a loose muzzle device with flop around killing accuracy. Not to mention that locktite SHOULD NEVER be used on rifle parts there bubba. :rolleyes:


Would make production quicker and easier, and my OCD would be grateful, I wouldn't have to shim to get the flats vertical if they were completely round lol.
What are you OCD? The wrench flats don't need to be vertical.
 
uhhhh .... if you want to retain any semblance of accuracy, hand tight is nowhere near tight enough because barrels vibrate with each shot and a loose muzzle device with flop around killing accuracy. Not to mention that locktite SHOULD NEVER be used on rifle parts there bubba. :rolleyes:



What are you OCD? The wrench flats don't need to be vertical.

Lol, it's 2 grunts hand tight, with blue locktite, it takes some heat and a strap wrench to get them off, they don't loosen up.
And yeah, I literally said in my post that my OCD requires the flats to be vertical.
It's a little early to be drunk typing there buddy, may want to switch to coffee lol.
 
uhhhh .... if you want to retain any semblance of accuracy, hand tight is nowhere near tight enough because barrels vibrate with each shot and a loose muzzle device with flop around killing accuracy. Not to mention that locktite SHOULD NEVER be used on rifle parts there bubba. :rolleyes:



What are you OCD? The wrench flats don't need to be vertical.
So you're simultaneously mad that his muzzle device is too loose and too tight? Youd make someone a good wife lol
 
Back
Top Bottom