NEA stock adapter problems

Trudel

Trudel

New member
EE Expired
Rating - 0%
0   0   0
Location
Saint-Boniface, MB
Good day,

The last two time I have gone shooting I have had problems with my NEA stock adapter comming loose after shooting a few mags with my CZ. Is this because I haven't installed it properly? I screw in the bolt as tight as I can and it still seems to happen, do I need to install a larger one and put a washer on? It gets so jiggly that it because almost impossible to shoulder. Any suggestions or help would be much appreciated, thanksin advance.
 
Trudel said:
Good day,

The last two time I have gone shooting I have had problems with my NEA stock adapter comming loose after shooting a few mags with my CZ. Is this because I haven't installed it properly? I screw in the bolt as tight as I can and it still seems to happen, do I need to install a larger one and put a washer on? It gets so jiggly that it because almost impossible to shoulder. Any suggestions or help would be much appreciated, thanksin advance.
Click to expand...

It's not the NEA product that's the problem. You really have to torque the screw down to get it to hold. In my experieince it takes more than just a big screw driver. If you have a tire iron with a slot end on it use it. Put the rifle between your knees and reef on that mother until your arms are sore. Then it will hold for you.

Or do the sissie thing that Armdsask said and use Loctite. :D

P.S. Just so you know, Armdsask is not his Avatar, he's male!!! I know it's hard to believe, but I just wanted to make that clear in case you missed his sig line....LMAO!!
 
Clobbersauras said:
P.S. Just so you know, Armdsask is not his Avatar, he's male!!! I know it's hard to believe, but I just wanted to make that clear in case you missed his sig line....LMAO!!
Click to expand...

Actually it is Armedsask. He has been eating low fat yogurt and taking yoga classes, but its mostly the jeans
 
Even with the blue sometimes it better if you use a heat gun from Crappy Tire to warm it up and make it alot easier to remove.Just watch your fingers when you touch it.Also purple loctite is made for small fasteners and is easier to remove but still does the job.
 
You must log in or register to reply here.
Back
Top Bottom