NEA15 hanguard missing T marks

Undergiver

Undergiver

CGN Ultra frequent flyer
Rating - 100%
70   0   0
Location
Sturgeon County, AB
Ryan do have install instructions for the handguard. I have the barrel indexed for the gas tube but the handguard does line up with the upper.

***Update*** the handguard is installed but there are no T marks on the handguard I received. Can you check your other stock and see if mine just missed that step in the production line at NEA ?

thanks
 
Last edited:
I've always just slid the handguard over the nut at the nearest index point and twisted it some it lined up,then tension the bolts.
 
OK that worked and the hand guard is installed and looks good but it is not "T" marked like advertised. There is also no "NEA" engraved on the side. I'm wondering it I got an unfinished hand guard ?
 
Last edited:
Mine was the same
I had to cut a new index chanel out for the gas tube to properly line up the handgaurd.
There was no making a nea upper match with a nea barrel nut and nea handgaurd.
For how cheap the 'stuff' is, kinda expected it to be as such.
 
will post a pic. The handguard cost more then both the upper and lower

20160606_193446_HDR_zpsn0vh7bux.jpg


Stag barrel and BCG, Colt LPK, DLASK XB1, WC bolt catch
20160606_193517_HDR_zpsaumrs8a9.jpg
 
Last edited:
SFRC should change their description of NEA handguards if they are not T marked now.

"Our 9" Float Quad Rail features our 3&9 o’clock Short Rails for accessory mounting and full length upper and lower rails. The upper rails are T-Marked for quick indexing of optics and accessories"
 
I just got a hold of NEA. Since they now cerakote their guns, they no longer mark them. The laser burns the paint.
 
You must log in or register to reply here.
Back
Top Bottom