Neck and full size combo?

ton45-II

Regular
Rating - 0%
0   0   0
Thinking out loud here. I don't know if it would work but here goes. Can I use a lee collet neck sizer then full size a case? I was thinking of doing this to to first fix run-outs and improve accuracy using the lee collet die then using a small base full size die to get standard SAAMI dimensions to feed reliably on two guns of the same caliber.

I wanted to standardize the ammunition for my 308s and make sure they feed reliably, since fire forming to the one chamber will not work with two rifles of the same caliber.

This make sense?
 
The FL sizer is designed to size the neck and the body.

I know what you are thinking but you would be better off to get a Redding Body Die if you want to go that route, and while your at it...get a Redding Bushing Neck sizing die and bushing.
 
Last edited:
The FL sizer is designed to size the neck and the body.

I know what you are thinking but you would be better off to get a Redding Body Die if you want to go that route, and while your at it...get a Redding Bushing Neck sizing die and bushing.

I just found that Redding Body die in their catalogue. Might just be the solution I'm looking for. Thanks!!:):
 
Back
Top Bottom