Need help - BCL 102 fixed stock

M

mantoined

Regular
Rating - 100%
13   0   0
Location
Montréal
Hi folks!

I got a BCL 102 last week and I really don't like the feeling of the cheap ajustable stock that it has on it.

I did some research to buy a fixed stock, I found so much informations and products available that I am a little confused about what can really fit with the BCL.

I want something that will fit without modifications (if possible!) and at low cost. I was looking for those two options:

https://www.magpul.com/products/moe-fixed-carbine-stock-commercial-spec

https://www.hogueinc.com/ar-15-m-16-overmolded-fixed-buttstock-fits-a2-buffer-tube-black-rubber

Thanks for your help
 
You need to buy a military spec stock...the one you have listed is a commercial spec stock...different width tube. I used a Magpul MOE adjustable (mil spec) on one...no problem. Fixed one should work...get the mil spec, though.
 
You are right, I have noticed the difference after sending the message. Thanks for the advise

So you think the fixed stock will be long enough to fit the buffer tube?
 
If you ordered the Magpul fixed stock you’re good as it’s meant for a collapsible stock. It will likely give a good length of pull. Normally they’re on the short side.

The Hogue would require a rifle length tube, spring and buffer. Due to the extra length on the rear of the receiver the length of pull will be quite bit more than an AR15.
 
You must log in or register to reply here.
Back
Top Bottom