NEW AR-15 Forends @ Dlask Arms Corp.

Dlask Arms

Dlask Arms

CGN Ultra frequent flyer
Business Member
Rating - 100%
51   0   0
Location
Delta, BC
We ordered these on a whim (along with some other product) to see if the quality was good. These are the same ones we used a few weeks ago to make our complete upper receivers. Because the response was so positive from customers that bought them we decided to place another large order. This time we got all of the available lengths : 7", 10", 12", 15" & 17". Some we are saving to make more uppers so get the remaining units while you can.

Found here :

https://dlaskarms.com/products/ar-15-free-float-hand-guard-m-lok-various-lengths
 
Mark-II said:
They use a standard barrel nut?
Click to expand...

No Sir. It is a proprietary barrel nut but has the same tabs as a standard nut for using an AR wrench to install it. Good system, in fact a GREAT system for the $. I have made 12 complete uppers so far using different lengths of these and they all assembled beautifully.
 
8x68 said:
Newb AR owner question: Will they work with S&W M&P 15 Sport II? Do they have the metal heatshield?
Click to expand...

You'll have to hack down the factory gas block, or put a low profile one on it.

I put a very similar one (Also Chinesium) on my M&P, and I just butchered the factory gas block. I'm a machinist, and I've worked as a metal fabricator, so I'm pretty comfortable with a grinder. Not that it's that difficult though. The easier route would probably be just buying a low profile gas block.
 
You must log in or register to reply here.
Back
Top Bottom