New bolt inside

id64

id64

CGN frequent flyer
Rating - 99%
99   1   0
Location
Toronto, Ontario
After failure of extractor had to get LMT enhanced 7.62 bolt. Still getting light strikes even with Wolf spring, but only tried Russian ammo. Need to try with Romanian surplus to see if new spring makes any difference. I hope you don't mind another picture :)

D4R_4486_1485.jpg
 
yeah, the joy of shooting surplus, recently I had some problems with a batch of mid 80's surplus ammo (in white cardboard and plastic bag), had a really bad case of of stuck casing in my XCR pistol, ended up cranking the gas setting to 4 to run it smoothly. as to the light primer strike double check your hammer spring compare it will your original spring make sure it is stiffer one.
 
hbean said:
yeah, the joy of shooting surplus, recently I had some problems with a batch of mid 80's surplus ammo (in white cardboard and plastic bag), had a really bad case of of stuck casing in my XCR pistol, ended up cranking the gas setting to 4 to run it smoothly. as to the light primer strike double check your hammer spring compare it will your original spring make sure it is stiffer one.
Click to expand...

Thanks for the suggestion. I did compare them and the one that I have is the stiffer one. People are saying that removing some material from the firing pin tail will do the trick.
 
You must log in or register to reply here.
Back
Top Bottom