New build done! Cadex, Defiance, Krieger.

shelby78

CGN Regular
Rating - 99.3%
148   1   0
After a year or more its finaly done. To be fair I had all the parts sitting for 8 months and never sent them out for chambering.

Hopefully this week I can break her in. She's a 6mmbr 20 inch barrel that I plan to mag feed. The bipod is just a piece of junk I had. I may go with a skipod as I have never tried one before.

I also had the rings kicking around and need to see if I can find some that drop the scope a bit.



2rm6vl1.jpg


ostszq.jpg
 
I love that open top. I have one in a .223 long range rig. I see that the top rail on that action doesn't conflict with the top of the fore end. Very nice! I had to trim my rail.

I look forward to your range session report!

BTW, those are mighty high rings!
 
Last edited:
The mag feeding solution is at this page www.primalrights they make an aics mag conversion for 6br. I need to order a couple as well. I modified a MDT polymer 223 mag and it works not too bad in my Cadex but it's not 100% reliable. Great looking rig. What twist rate and bullets do you plan on using?
 
The mag feeding solution is at this page www.primalrights they make an aics mag conversion for 6br. I need to order a couple as well. I modified a MDT polymer 223 mag and it works not too bad in my Cadex but it's not 100% reliable. Great looking rig. What twist rate and bullets do you plan on using?


I was going to mod the mags myself but if someone has a easy kit I'm all in. Not sure if they ship to Canada or not as it would not let me thru there site.

I do need different rings. The other set I have were mediums and were probly 1/4 inch off being able to mount the scope.

Barrel is a 8 turn. I have 5 boxes of Lapua 105's I bought to get brass from. I also have Berger 105's and flat base 88's. My main range only goes out to 200 so I will set it up to be the most accurate there.
 
Back
Top Bottom