NEW Marlin 795 tactical sights, Opinion wanted

F

fmj50

New member
Rating - 0%
0   0   0
Location
Colorado
Just tested this new sight set for the Marlin 795, opinions please...
Ncstar rail, UTG rear sight, Trueshot AK style frint sight, ATI M/60 stock modified. 25 yard test target

IMG_6219_zpszayiafyi.jpg


IMG_20170119_100515377_zpsnx1euo2f.jpg


IMG_6212_zpstqyw0pt1.jpg



IMG_20170118_135856521_zpsbo9le361.jpg
 
Cool to see something new being done with the 795, not that much of an aftermarket for these great semis. I'm sure your photos will inspire! Me? Mine has a tuned trigger, cheap $50 Chinese scope...and is as reliable/accurate as I could ever hope it to be. About all I'll do with mine, though a walnut stock would be nice. :)
 
I think it looks pretty nice, the rail adapter looks like it's sized a bit wrong but if it holds cleanly that's all that matters. It looks like it could use a shim along the top if you wanted it even.
A fiber optic front sight post would be nice, What do you think of it since you've actually used it?

IMG_6219_zpszayiafyi.jpg
 
Can-down said:
I think it looks pretty nice, the rail adapter looks like it's sized a bit wrong but if it holds cleanly that's all that matters. It looks like it could use a shim along the top if you wanted it even.
A fiber optic front sight post would be nice, What do you think of it since you've actually used it?

IMG_6219_zpszayiafyi.jpg
Click to expand...

I actually have a Crosman Vantage ( break barrel air gun ) with this UTG rear sight. But a better dovetail to weaver adapter and a fibre optic front post sight. Its awesome, works like a reddot.
 
The rail has that bottom radius, but it was the only one the right height, yes a shim might help, but it stayed in place for 200 rounds.
Not the best group, I was really trying to verify the sights worked and stayed in place.
 
fmj50 said:
The rail has that bottom radius, but it was the only one the right height, yes a shim might help, but it stayed in place for 200 rounds.
Not the best group, I was really trying to verify the sights worked and stayed in place.
Click to expand...

s-l1000.jpg


These work well.

I run these on my vantage, took a bit of work to get them on.

hawke-2-piece-11mm-dovetail-base-to-weaver-adapters-low-profile-2009-p.jpg
 
I have that same utg sight that I had on a bl22 with a Lyman ATC front sight. It did shoot pretty decent groups as well but ended up going back to my Williams peep sight cause I seemed to get better groups with it. Also used the same dovetail to weaver adapter that okshooter suggested and it worked good as well as keeping the sight lower to reciever.
 
It was the low profile on top that I used but m sure by looking at your front sight that it's much higher than my Lyman so it it would be to low for you. I ordered mine off Amazon and I'm pretty sure there was quite a few different ones.
 
You must log in or register to reply here.
Back
Top Bottom