piHello all Moison PU scope snipers out there, I wanted to give everyone a heads up on a new mount/system I designed to put a modern center adjustment high power scope on your Moison sniper to wring out the best accuracy for long range shooting.
Machined out of 6061-T6 billet Aluminum, it will attach in the same way as a regular PU mount but allow you to mount a modern scope with simple weaver or Warne rings, you will also be able to adjust left, right, and cant (with two 8-32 set screws) to center scope zero.
I will be including two weaver #79 bases and screws that you can attach in two of four positions to the vertical side and add your mounts (at a right angle) for over the bore center alignment and to clear your existing bolt handle.
I designed the mount spacing around weaver KT-15/leupold 40/42mm bell scopes and similar sized optics.
IT will be Hard clear anodized .001 deep (.002
.)and the part should be a medium dark charcoal grey color when finished, Any suggestions for different colors? Green OD, Black, Red?
c20.picturetrail.com/VO...015288.jpg
Pricing will be $65.00 plus $5.00 shipping for the mount/and two weaver bases/screws only (PU rifle receiver base is not included but I may offer in the future, or you can contact other manufacturers for them but I cannot guarantee compatibility.
Feel free to contact me if anyone has some comments that can improve this product.
Thank you.
Frank Ambruso
6MM-Intl
226 F Street
Redwood City, Ca 94063
ambruso@rcn.com
Home: 650-363-1651
Cell: 650-504-8401
Machined out of 6061-T6 billet Aluminum, it will attach in the same way as a regular PU mount but allow you to mount a modern scope with simple weaver or Warne rings, you will also be able to adjust left, right, and cant (with two 8-32 set screws) to center scope zero.
I will be including two weaver #79 bases and screws that you can attach in two of four positions to the vertical side and add your mounts (at a right angle) for over the bore center alignment and to clear your existing bolt handle.
I designed the mount spacing around weaver KT-15/leupold 40/42mm bell scopes and similar sized optics.
IT will be Hard clear anodized .001 deep (.002
.)and the part should be a medium dark charcoal grey color when finished, Any suggestions for different colors? Green OD, Black, Red?c20.picturetrail.com/VO...015288.jpg
Pricing will be $65.00 plus $5.00 shipping for the mount/and two weaver bases/screws only (PU rifle receiver base is not included but I may offer in the future, or you can contact other manufacturers for them but I cannot guarantee compatibility.
Feel free to contact me if anyone has some comments that can improve this product.
Thank you.
Frank Ambruso
6MM-Intl
226 F Street
Redwood City, Ca 94063
ambruso@rcn.com
Home: 650-363-1651
Cell: 650-504-8401
