New Services from Dlask Arms Corp.
- Thread starter Dlask Arms
- Start date
So after much delay and 2 attempts by Green Mountain to ship us the 7.62 blanks they are finally on their way. Apparently someone at Fed-Ex in the US didn't think they should be exporting barrells despite State Dept. approval...haters.
They cost of re-barrelling will start at $550 for a basic job. This includes us removing the old barrel on a milling machine, not an easy job, and then into the CNC to cut threads in the receiver. Once that's done we will install a new stainless Green Mountain barrel and headspace it. If you want the Deluxe job it includes us stripping the coating from the receiver after the new barrel is installed and sending it out to be ceracoated in your choice of colour. This will add approx. $200 to the price of the job depending on the amount of units we send out at a time to be coated and the going rate for the coating.
There are NO plans to do this mod in any caliber other than 7.62 x 39.
Leigh
Dlask Arms Corp.
They cost of re-barrelling will start at $550 for a basic job. This includes us removing the old barrel on a milling machine, not an easy job, and then into the CNC to cut threads in the receiver. Once that's done we will install a new stainless Green Mountain barrel and headspace it. If you want the Deluxe job it includes us stripping the coating from the receiver after the new barrel is installed and sending it out to be ceracoated in your choice of colour. This will add approx. $200 to the price of the job depending on the amount of units we send out at a time to be coated and the going rate for the coating.
There are NO plans to do this mod in any caliber other than 7.62 x 39.
Leigh
Dlask Arms Corp.
DaveMachine
CGN Ultra frequent flyer
- Location
- That one place with a cowboy complex
I'm going to express interest in a 6.5 Grendel barrel.
Oh, and what about different barrel profiles? Eg. thicker
Oh, and what about different barrel profiles? Eg. thicker
personaguru
Regular
- Location
- grand-digue NB
can you profile the new barrel and can thay be threaded for muzzle device and fluted?
Rusty Joots
CGN Regular
- Location
- Spruce Grove, Ab
That's awesome nice work
It depends on how short. If you want the uber stumpy 7" then NO unless you supply the additional components. Our barrel swap service uses the existing parts from your rifle to put on the new barrel.
Nothing except the stock 7.62 x 39, sorry. Caliber conversions are not just a matter of changing barrels. I recently did a custom barrel for a customer that wanted something a little different. The O.D. of the ribs are as wide as possible while still being able to use the original lower hand guard :
We had it Nitride finished after machining and it came out as one of the nicest I have done.
Leigh
Attachments
