New XCR .223's from Wolvwerine

[The Giant]

XCR upper. Mainly so I don't have to rezero optics just keep the optic on the rail of each upper. And secondly so I don't have to play with the barrel bolt. I think its kinda sketchy anyways.

It would be easier that's for sure. Changing to .223 from 7.62 I only had to lower the aim a few clicks. About five shots and I was on target again. It's not that bad to rezero but I hear ya.

Umm Terra my upper is defective. Ya defective that's it. Maybe you can send me a replacement?

 

[Camp Cook]

I'm really liking this idea... I would want the complete upper in a 1 - 9.5" or 10" barrel twist rate 6mm-6.8SPC (6.8SPC necked down to 6mm) I'm thinking that this would be an awesome deer/predator combo...

I also want a 6X45 (6mm/223) chambered barrel all I need is a barrel and I would not have an issue with just changing out the barrel/scope each time...

 

[Throttle_monkey1]

I want a complete pdw upper...

 

[Ffynn]

I don't feel like screwing with the barrel bolt and stuff. I don't care if it would cost more. Just slapping a different upper is easier for me and I don't even have to worry about optics then just keep the zeroed optic I use for each on each upper.

Don't you need to unscrew the barrel bolt to clean thoroughly? IIRC you can't get at the gas tube without taking the barrel out. So you'll need to 'screw' with the barrel bolt anyway if you want to completely clean the rifle.

 

[MosinNagantM44]

no u can take the gas setting nut thingy off and clean the gas tube.

 

[Ffynn]

LOL. That almost seems too obvious.... I feel a little retarded now, and I think I'm going to have to change the way I clean my rifle..

Oh man...