No Jam Remington Mag Follower - 12GA - Type 3..... Perfect for the Kel Tec KSG

srnm

srnm

CGN frequent flyer
Rating - 100%
61   0   0
Location
Ontario
Just wanted to say how great the "No Jam Remington Mag Follower - 12GA - Type 3" are. I have these in all my shotguns and decided to switch out the factory mag followers in my Kel Tec KSG as they are extremely cheap, flimsy, and weren't sliding as smooth as I wanted to. I installed the "No Jam Remington Mag Follower - 12GA - Type 3" which were perfect fit and to this day, I have put 250 rds through it with zero problems. I have also installed them on another members Kel Tec KSG at my local range. Great job on these mag followers! I hope you come up with some more awesome shotgun parts.

0fZRb9n.jpg

fI6bxI5.jpg
 
I have to admit the main reason why I wanted them in my KSG is the HiViz Green, easy to spot under any condition. The mag followers are harder to see then in a regular pump action shotgun. Installing them is a challenge as you need special a special wrench to remove the barrel nut (using an impact gun helps a lot, there's no way to loosen it by hand, tons of loctite) and I wasn't comfortable using a heat gun with so much polymer/plastic around, and then another special tool to remove the mag tube end caps. took about an hour to do mine as it was the first one and I wasn't too sure what I was doing. but the other 2 I did only took about 25-30 minutes.
 
You must log in or register to reply here.
Back
Top Bottom