Hello CGN,
Recently got a No1 Mk3. Took the forend off first and I realized the square end of the stock bolt was not striaght so to speak. Loosened so that it will fit the forend notch, but the stock became loose. So I then added a washer with the bolt. I think there is a original washer in there but it did not come out.
Whats the common approach to this situation?
Thanks!
Recently got a No1 Mk3. Took the forend off first and I realized the square end of the stock bolt was not striaght so to speak. Loosened so that it will fit the forend notch, but the stock became loose. So I then added a washer with the bolt. I think there is a original washer in there but it did not come out.
Whats the common approach to this situation?
Thanks!
