NOE push through sizers??

I haven't tried the sizers but I've ordered direct from NOE many times. There is no Canadian supplier. If you join the NOE mailing list he has sales for 10% and up to 20% some times. That's when I order. It usually covers the shipping cost.

I wouldn't hesitate to by the sizers if I needed one though, NOE makes quality molds and sizers would be even easier to make. I'm sure they work great.

For the cost, I personally would order a lee one and modify it to my needs though.
 
I bought the conversion die for the star lube sizer and now just buy the inserts, for that one I wish there was a set screw to hold the insert, regardless it is some top quality gear and matches the quality of their molds, I wouldn't hesitate to recommend their sizing dies to anyone
 
I have used the NOE sizers (311 thru 316) and they work great. I took advantage of one of the sales and found there was no better deal anywhere on sizers. If you only want one or two sizes then the Lee is lower cost, but if you want around 3 or 4+ then look at NOE.

The system does not work with a Co-ax press, although someone with a lot if patience may be able to do it.

K.
 
The NOE sizers are good, but the metal seems to tarnish easily.
Sometimes it requires a bit of unexpected force to run the bullets through, especially if you're sizing down a few thou and have a hard alloy.
A bit of oil applied with the fingers for the first few, and then every so often, helps greatly.
 
You must log in or register to reply here.
Back
Top Bottom