Norinco AR15 Magazine Follwer

cigarbufff

cigarbufff

CGN frequent flyer
Rating - 100%
49   0   0
Location
GTA
Hey whats up. just wondering if the followers on the stock norc ar15 mags can be changed? i heard they cant bcuz the follower wont make it pass the internal pin? is this correct. thanks

Reason why i am asking is i want to put the magpul anti tilt followers in
 
Just out of curiosity is there a special attachment to these stock Norico AR mags? you can buy good quality mags for around $20 a pop, it seems to me to be a better way to go :)
 
hbean said:
Just out of curiosity is there a special attachment to these stock Norico AR mags? you can buy good quality mags for around $20 a pop, it seems to me to be a better way to go :)
Click to expand...

no attachment at all.. i have the followers sitting around just wondering if they could be installed.
 
If (and I'm not 100% sure they do) they use the same method of 'pinning' the AR mags that they use on the M14 mags, removing the follower would be removing the capacity restricting device. If you did that, you would be required to pin the mag in the regular fashion (drill the body and throw in a rivet) All you'd get out of the Norc mag would be the body.
 
enefgee said:
If (and I'm not 100% sure they do) they use the same method of 'pinning' the AR mags that they use on the M14 mags, removing the follower would be removing the capacity restricting device. If you did that, you would be required to pin the mag in the regular fashion (drill the body and throw in a rivet) All you'd get out of the Norc mag would be the body.
Click to expand...

ty for your input! I was afraid of that
 
You must log in or register to reply here.
Back
Top Bottom