Norinco CQA gas block removal

Yup there on tight though :(

Start with a tapered punch and a 24oz ball peen hammer "REMEMBER THE PINS ARE TAPERED and only come out one way" Also make sure you are hammering on a solid suface or you will loose hammer force from the bounce.

This will help too if you can order one
p_080000252_1.jpg
 
Last edited:
They do come off apparently, but from some of the previous posts I don't think it was as easy as just knocking a pin out. I think there were some posts involving grinding it off with a dremel IIRC.
 
Yup, its a pain to get off for many people. I was lucky and had to cut mine off with a dremel. If you go really slow it works out pretty well, just had to replace the handguard cap that I had to cut through as well.
 
You must log in or register to reply here.
Back
Top Bottom