norinco disassembly trigger group cant get out

[sogone2day]

trying to clean up my shorty and have been looking in the manual and youtube. Seems simple from what ive seen but on mine i lift the trigger gaurd and pull on it but its a no go looks super tight and dont wanna use to much force on the gaurd.
Anyone have the trick to getting this bad boy out?

thanks

 

[cptseawolf]

use a small screwdriver thru the hole in the back of the guard and pry it. Mines too stiff to do by hand as well. Should easily just pop up with a tool.

 

[sogone2day]

got it out not with out a bloody finger though

thanks it was a hard pull

 

[gnmontey]

Safety off, and #### the action, before attempting trigger group removal.

M

 

[moose2hunt]

Had the same thing with mine ..i pried it out then lightly polished the contact pionts that fit so tight ....just enogh...so it goes in and out with out fighting with it ...mine was stuck stuck stuck ...use a light and see where yours contacts hard .......and before any one says anything about sanding the triger mec its self its just the sides that slide in to the reciever ...

 

[Hungry]

Tight trigger groups? Did someone say tight trigger groups? That's magic to my ears. Match rifles like them in there nice and tight! Count your blessings! I like a tough-to-clamp down rifle!

Cheers,
Barney

 

[moose2hunt]

mine is still tough ...but at leats i dont have to pry it out ...