Norinco M1000 assembling issue

[bahamot]

Hi! I can't put my barrel in.... The bolt don't want to move...is there a tricks???? We're a couple who buy it and we have all the same problem.. Someone help please.

s!

 

[GUB]

Try holding the spring down with one hand and let the op rod fore end slip over the guide. Then let bolt slide in? I think it's a tight fit at the op rod fore end and won't line up properly with spring resistance???
Then put in the bolt charging handle.
That will hold ever thing in place.
Then drop in your barrel, then front stock and locking nut

 

[GUB]

Another tip is to assemble the gun vertical on a counter.
Muzzle up..

 

[iger13]

Behemot, you need to be patient. I had the same problem. Just patients

 

[bahamot]

that's the thing.. my patient reach is limit ...hahahahaha

 

[bahamot]

Another tip is to assemble the gun vertical on a counter.
Muzzle up..

I try any way possible vertical..horizontal...diagonal too ;-)

 

[GUB]

Your trigger is cocked back ? Or out of the gun?
Hey CA ! I asked a while back . But any mags for the M1000?

 

[bahamot]

Your trigger is cocked back ? Or out of the gun?
Hey CA ! I asked a while back . But any mags for the M1000?

i try with the trigger cocked back and also out of the gun....and no you can't buy any mags..

 

[DiMP]

Re: The mags
I remember in a post before that CanAm bought the whole lot of these from an R&D facility (ie: not a full production run, so they bought everything they had). The had mentioned a few extra mags, but they came off scratch and dent firearms so to say, so you'd pay most the price of the gun for them

 

[bahamot]

yeah!!! it's done !!! my problem was in the main rode, she's not perfectly round....so the part who attach to the bolt can't slinde over it.... sandpaper was the solution finally......