Norinco m305 scope mount

[streetmedic63]

I have the Norinco M305 and am looking for a scope mount. The issue with some mounts is that it blocks the spent cartridge from cleanly ejecting. Does anyone have any suggestions for a mount? Thanks.

 

[crud]

I use the Arms 18. Works great.

 

[chalkriver]

You may need to trim a couple coils off of the extractor and ejector springs inside the bolt to get the rifle to eject reliably with some rifles using an Arms 18 mount. Great scope mounts though . I have a couple and may be selling one soon ...

 

[Mister Donut]

I have the Norinco M305 and am looking for a scope mount. The issue with some mounts is that it blocks the spent cartridge from cleanly ejecting. Does anyone have any suggestions for a mount? Thanks.

I use an M14.ca CASM II mount and have never had any issues with spent casings ejecting properly:

http://2.bp.########.com/-S-9i4e7TRBA/U92d1Ah69bI/AAAAAAAAUeg/K3ONfxfkwQw/s1600/P8023570.JPG

Loads of clearance:

http://1.bp.########.com/-bwr47gjc2wg/U92d-yyZSnI/AAAAAAAAUfI/_l7mkk2RFno/s1600/P8023580.JPG

 

[ArxTac]

Check out the Promag mount, I think Mystic Precision (site's sponsor) carries it.

 

[Oddjob70]

I use an M14.ca CASM II mount and have never had any issues with spent casings ejecting properly:

http://2.bp.########.com/-S-9i4e7TRBA/U92d1Ah69bI/AAAAAAAAUeg/K3ONfxfkwQw/s1600/P8023570.JPG

Loads of clearance:

http://1.bp.########.com/-bwr47gjc2wg/U92d-yyZSnI/AAAAAAAAUfI/_l7mkk2RFno/s1600/P8023580.JPG

Jeeezuuzz...look at that scope! you could count the fleas on a coyotes back with that sucker...

 

[sksscrew]

CASM mount

I use an M14.ca CASM II mount and have never had any issues with spent casings ejecting properly.


I love this one ^^^^^

 

[Parabelum]

I have a CASM II also I think buying Canadian is the way to go on that one.

 

[Katana]

I've had fabulous results with every Smith Enterprises mount I've had, 4 in total...

 

[liberty]

I only have experience with the Bassett mount,,,works good and you can use the irons at the same time,,,remove it with one screw, reattach,,, and it returns to zero,,,

I like to shoot both scope and iron sights so it works for me....

 

[ipscgraz]

I started with an ARMS 18 but the receiver on my norc is not square to the bore; the front of the receiver is thicker (actually a bonus!) and I wound up with an m14.ca mount.

If you go M14.ca stay with low rings.