norinco M93 woodsman trigger housing reassembly issue

K

Kryogen

CGN Ultra frequent flyer
Rating - 100%
11   0   0
Location
Quebec
Fixed: see post #3

Could not resist the urge to disassemble my norinco m93 woodsman trigger assembly to clean it (crapload of parts)

I got most of it back together, but I am having a hard time trying to reassemble the last parts:

the safety, the firing pin block retractor and the hammer together.
Somehow, the firing pin block retractor fits on the hammer, and you have to place that in the housing and then slide the safety(with pin) on that without all that moving, and I'm not even sure how to position the firing pin block retractor.

Anyone?
 
Last edited:
Grizzly Adams said:
find the dis -assembly instructions for the Colt Woodsman, parent of this gun.;) Not identical, but close enough. Grizz
Click to expand...
No, not close enough....

After 2 hours of raging, I finally got it.
Insert the safety switch halfway in. Drop the firing pin block retractor prongs facing right, with tweezers on the pin, then move it forward so it is activated by the trigger bar. Slowly retract the pin just so it holds the retractor there, and insert the hammer assembly(pin head facing left, opposite of the norinco parts diagram[...] , then push the pin fully in.
Got it :|

My suggestion: do not disassemble this. It's a miracle I got it back together, took me close to 4 hours.
At least it's spotless clean, but never again.
 
Last edited:
I blow the crud out of mine with break cleaner, and then lube with WD40!

M
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom