Anyone ever install one of these into their P14 boomer project? It looks fairly simple--mill a small area at the rear of the box for proper fit into the P14 receiver, and take a small amount of material out the feed ramp. Any other info I should know? Or past experiences?
Numrich mag box install--P14
- Thread starter kell2784
- Start date
I've done a few, I just used a file. Pretty straight forward, trim what you need, make sure it's a good fit all around, file a little and try it, repeat. A mill would make it faster, but it's damn hard to back up with one, so go slow. - dan
