A fellow stop by the shop to give me 220 full medal jacketed bullets that he thought were for an 8 mm x 57 Mauser. He said that they were too large in diameter to seat in the 8mm brass. I measured a bullet and found the following
205.5 grains
1.351 inches over all in length
long boat tail
a cannelure aprox 1/2 way tip to base
diameter at rear end of .331 of a inch
diameter from cannelure to pointed tip 3.21 inches to a sharp point
these bullet show no sign being pulled and are brass solid jacked
Help!
205.5 grains
1.351 inches over all in length
long boat tail
a cannelure aprox 1/2 way tip to base
diameter at rear end of .331 of a inch
diameter from cannelure to pointed tip 3.21 inches to a sharp point
these bullet show no sign being pulled and are brass solid jacked
Help!