Odd grooved reciever 14.6mm

H

hunter148

Regular
Rating - 100%
103   0   0
Location
Ontario
Looking for a little info if possible. Recently bought a PPK Brno KMS 619 9mm carbine and have fallen for this little rig and am looking for a peep site as I would prefer not to put glass on it or drill and tap unless I absolutely have to. Same old story, can't hardly see the rear clearly and since it already has a fairly high, sweated on front site a peep would work for my needs.

Groove on the receiver is 14.6mm inside and 15.7 across the flat, which is a bit radiused. I have been pulling my hair out trying to find something so any advice or direction would be appreciated

Thanks in advance
 
It’s a 16mm European dovetail. Old CZ, and others, used this now obsolete standard. Best of luck on your search, I’m sure stuff exists, but I don’t know where.

Edit: NECG has a 16mm dovetail peep sight that fits the CZ 527. Might be worth a check?
 
Was looking at the Williams 5D-GR or the FP-GR as it will have to be as low to the receiver as possible. 16mm works out to a smidge over .600 inches and these two sites claim to open from .300" to .600" grooved receivers.

If anyone can verify or has one or any other input it would be gladly accepted. I think the NECG will sit to high and the from site of the gun is a sweated ring affair so changing it is a no go.

Thanks again
 
You must log in or register to reply here.
Back
Top Bottom