I threw this up on rimfire central, might as well rack your guys brains too.
The extractors are not gripping the case, removing the bolt and sticking a case into it by hand makes it obvious it'll never grip the rim in it's present state.
When I received the rifle, it had no extractors installed. Parts were received from numrich.
Looking from the rear to the front(from a top), the sharp right angled extractor is on the right hand side of the bolt. I believe this is the correct orientation.
Some poor photos of the current 84c/4c I have. I can set the fired case in the bolt face without moving either extractor.
The extractors are not gripping the case, removing the bolt and sticking a case into it by hand makes it obvious it'll never grip the rim in it's present state.
When I received the rifle, it had no extractors installed. Parts were received from numrich.
Looking from the rear to the front(from a top), the sharp right angled extractor is on the right hand side of the bolt. I believe this is the correct orientation.
Some poor photos of the current 84c/4c I have. I can set the fired case in the bolt face without moving either extractor.
